********************************************************************************
**                                                                            **
**  These settings toggle behavioral changes.                                 **
**                                                                            **
********************************************************************************

$SET    aseIgnCount       ; SET    for ignition event count decay on ASE (B&G),
                          ; SETNOT for seconds.

$SET    egoIgnCount       ; SET    for ignition event count on EGO correction (B&G),
                          ; SETNOT for 0.01 sec time-based updates.

$SET    idlIgnCount       ; SET    for ignition event count on idle correction (BF),
                          ; SETNOT for 0.01 sec time-based correction.

$SETNOT taeIgnCount       ; SET    for ignition event count decay on AE,
                          ; SETNOT for 0.1 sec time-based (B&G).

$SETNOT interpolatedPrime ; SET    for priming pulse interpolated from CLT,
                          ; SETNOT for fixed value (B&G).

$SETNOT hybridAlphaN      ; SETNOT for pure alpha-N mode (B&G),
                          ; SET    for Ferrari F40 hybrid alpha-N mode.

********************************************************************************
**                                                                            **
**  The following toggle the existence of code to implement the features.     **
**  Leaving things out makes the code smaller and faster.                     **
**                                                                            **
********************************************************************************

$SET    crankingPW2       ; SET    for bank1 and bank2 to both deliver fuel while cranking (B&G).
                          ; SETNOT for bank1 only, probably water on bank2.

$SETNOT Nitrous           ; Simple on-off nitrous control.
$SETNOT BoostControl      ; PWM boost controller using PD algorithm.
$SETNOT shiftLight        ; Assemble in the 3-stage shift light.

; These next two are mutually exclusive as the implementations both
; use portA sw1 on the daughter board.  If one is SET, the other must
; be SETNOT!

$SET    launchControl     ; Secondary rev limiter enabled via switch on sw1.
$SETNOT ptaCounter        ; Put a tach input on sw1.

********************************************************************************